|
Denne identifikatoren kan du bruke til å sitere eller lenke til denne innførselen:
http://hdl.handle.net/2282/436
|
| Tittel: | Assessment of mercury emission at Norcem's cement kiln by use of 203 Hg tracer |
| Forfattere: | Eriksen, Dag Øistein
Tokheim, Lars-André
Eriksen, T.A.
Meyer, Julien
Qvenild, Carsten |
| Dato: | 2007 |
| Forlagets versjon: | http://dx.doi.org/10.1007/s10967-007-0940-4 |
| Sammendrag: | In manufacture of cement clinker, mercury is introduced in the cement kiln system via the fuels and as constituents in the raw materials, i.e.,
limestone, iron ore, etc. The permissible emission of Hg to air is very low (0.05 mg/Nm3) due to its toxicity. Thus, it is important to know how
mercury distributes and behaves in the kiln system. The objective of the study was to measure the distribution of mercury in the kiln system, to
measure the hold up time of Hg, to measure the portion of emission through the chimneys, and to see the dependence of the injection sites on these
parameters. The results showed that the amounts of mercury being emitted through the exhaust gases were largely dependent on where it was
injected. The residence time of mercury in the system was nevertheless long, after 10 hours it was still increase in the count rate of the mercury
absorbed. There was also an immediate increase in the filter dust, but nothing could be measured in the clinker. This knowledge is needed for the
reduction of mercury emissions. |
| Nøkkelord: | Cement clinkers
Emissions
Mercury
Cement kilns |
| Forlag: | Springer |
| Dokumenttype: | Journal article |
| URI: | http://hdl.handle.net/2282/436 |
| Vises i samlingene: | Institutt for prosess-, energi- og miljøteknologi
|
Denne innførselen er lisensiert under en brukslisens. Alle innførsler i TEORA er beskyttet av opphavsrett.
|
|
